23
DHOLLANDIA
7.7
RECOMMENDED DAILY PRE-TRIP INSPECTION
WARNING
Using a ramp that is damaged or improperly serviced, can put the operator and bystanders at great risk of serious bodily injury
and death.
To avoid this risk, inspect the ramp prior to the first use of each day. Ensure that all safety systems and all functions operate
correctly, and that no maintenance or repair is required.
If any unsafe condition exists or unusual noises or movements are noticed, DO NOT use the ramp and contact an authorized
DHOLLANDIA agent. [see Notice].
DO NOT cover up any accidents or damage; it can be dangerous to you, your co-workers, and other persons.
NOTICE
Authorized DHOLLANDIA service agents may be found at www.dhollandia.com or by calling your regional DHOLLANDIA distributor.
See page 3 for contact info.
Before operating the ramp, the operator must conduct the following daily pre-trip inspection. Use caution: stay clear of the
area directly behind and underneath the platform while conducting the daily pre-trip inspection.
Prior to opening the doors, make sure that the automatic locks are still engaged and the ramp is not leaning against the
doors. When opening the doors and deploying the ramp, ALWAYS stand clear of the range of motion of the ramp!
Replace missing, worn or illegible warning decals immediately. See page 3 for contact info.
Follow the instructions in section 8 from page 25 onwards to deploy the platform and continue the checks:
Visually inspect the general condition of the ramp frame and platform. Look for cracks or deformations in the material and
welds.
If so equipped, visually inspect the general condition of the mechanical support legs. Look for cracks or deformation in the
material and welds. Make sure the support legs and the outboard platform edge are in firm contact with the ground when
the platform is deployed.
Make sure all pivot pins in the ramp frame and platform are properly locked and secured.
Inspect all attachments such as handles, wheels, locks etc. Check if they are still functional and properly fixed.
Make sure the platform surface is clean. Remove any snow, mud, dirt, debris, or slippery liquids. Make sure you wear
safety-toe shoes with a good non-slip sole.
Perform all movements several times. Use the operating instructions in section 8 for guidance.
Make sure all movements occur smoothly and without any unusual noises.
Make sure there is no excess play in the hinges between the various platform sections. Make sure there is no excess
deformation when the platform is loaded and the ramp can be used safely.
Remember: if any part of the pre-trip inspection reveals a need for service or repair
DO NOT use the ramp until it has been serviced or repaired by a qualified service technician.
