PPC Test Port Connections Kit
Installation Instructions
PPC is a trademark, registered and otherwise, of
DH Instruments, a Fluke Company
Document 560021a
071023
DH Instruments, a Fluke Company
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Tel 602.431.9100
Fax 602.431.9559
www.dhinstruments.com
INTERCONNECTIONS KIT, P/N 401460
•
1
401459
Quick connector on stand
•
1
101988-Z
1/8 in. stainless steel tubing (75 cm)
•
1
100319
1/8 in. swage x 1/8 in. NPT male adaptor
•
1
102116
Quick connector stem, 1/8 in. NPTF
•
1
102117
Quick connector stem, 1/4 in. NPTF
•
1
102184
Reducer, 1/4 in. swage x 1/8 in. swage
TO CONNECT TO THE PPC
n
Screw the 1/8 in. swage x 1/8 in. NPT male adaptor into the PPC test port using teflon tape as a seal.
o
Install reducer into quick connector on stand.
p
Position quick connector on stand on bench or other stable surface. (Mounting is optional, holes are
provided.)
q
To connect PPC test port to the quick connect stand cut 1/8 in. SS tubing to desired length, bend as
needed including 90
°
angle under reducer.
1/8 in. SS tubing can be bent by hand to desired shape but use caution not to kink the tube.
r
Swage the 1/8 in. SS tube to adaptor on PPC and to reducer on quick connect stand.
