DH electronics 96Boards Avenger96, Getting Started, Page: 11 / 19

Avenger96 – Getting Started DH electronics GmbH
R03 DOC_Getting-Started-588-200.docx Page 11 / 19
1.1.7 JTAG-Connectors
As a standard the JTAG-connector X12 is not populated on the Avenger96, but in case JTAG is needed, there are
two ways to connect to it:
Tag-Connect (X13 and X14):
The Avenger96 has a standard Tag-Connect TC2050 footprint. With this design JTAG can be accessed with a
standardized TC2050-IDC-NL-Cable. In order to hold the cable in place, there is also an TC2050-CLIP available,
which locks the cable to the board.
The Tag-Connect footprint is placed on the top side of the Avenger96 as well as on the bottom side. This way the
connector can be used on either side of the board.
Pin Net
1
+1V8
2
SYS_JTMS-SWDIO
3
GND
4
SYS_JTCK-SWCLK
5 GND
6
SYS_JTDO-SWO
7
SYS_JTRST
8
SYS_JTDI
9
Not Connected
10
Not Connected