DGSHAPE VL-300, User Manual

Page: 5 / 16

Getting Started
Conditions for Material When Imprinting Curved Surfaces
The table and figure below show the recommended imprint area with respect to the diameter of the cylinder
formed from an extended curved surface. Note, however, that the following conditions are assumed.
Material with an extended curved surface has circularity.
Diameter of cylinder with
extended curved surface (ø) Recommended imprint area (A)
10 mm (0.394 in.) 2.0 mm (0.078 in.)
20 mm (0.79 in.) 2.8 mm (0.11 in.)
30 mm (1.19 in.) 3.4 mm (0.133 in.)
4