Page 16 of 53
8000-INS-UMENG Rev. 4
The
Average
preference turns on the frame-to-frame B-Scan averaging algorithm. For
slower processors, averaging can be turned off to improve display performance at the
expense of image quality.
The
Interpolate
preference enables or disables the linear interpolation algorithm. For
slower processors, interpolation can be turned off to improve display performance at the
expense of image quality.
12.3
B-Scan Page Preferences
The B-Scan Page Preferences allow the user to adjust image reference, scan speed
and scan/record settings.
The green line of the
Image Reference
setting
indicates the side of the image/video that will
correspond to the top position on the probe.
Note:
Changing the image reference setting
will change the orientation of the images
stored in the database. If this reference is
changed after images have been acquired, any
measurements overlaying the image will need
to be redrawn.
The
Scan Speed
setting determines the
number of frames that are acquired per second
during a scan.
The Start Scan Button Configuration setting
determines how the
Scan
and
Record
buttons
on the B-Scan page can be configured to
operate together or independently.
Scan and Record:
When the
Start
Scan
button is clicked to start a scan, the
software will automatically record video. Recording will stop when the scan is
stopped.
Scan Only:
When the
Start Scan
button is clicked, the scan will start; however,
video will not be recorded until the
Record
button is clicked. Recording can be
toggled on/off as needed during a scan.
