DFSK Seres 3 2019, User Manual, Page: 97 / 233

Instrument and Control Switch
- 96 -
③
The windows position exceeds the
scope of the initial learning position;
④
The system losses power over 15s
under the un-sleeping state or over
600s under sleep state;
⑤
The system shows the signal error
of the power windows position
；
⑥
The same window starts anti-pinch
function for two times.
Windows Self-learning
Function
When the anti-pinch function is
invalid, it can be recovered by
self-learning;
When the motor start-stop button is set
at “ON”, press the front left (rear
front/front right/rear right) window
lifting button to lift the window to the
top and then release it, press such
button again to the top and stall for 2s
and then down the window to the
bottom, lift the window to the top
again to finish the self-learning;
Sunroof
1. Button 4 controls the curtain of
panoramic sunroof. If you touch it
≥250ms, it starts manual mode; and
if you touch it
＜ 250ms, it starts
automatic mode.
2. Button 5 controls the curtain of
panoramic sunroof. If you touch it
≥250ms, it starts manual mode; and
if you touch it
＜ 250ms, it starts
automatic mode.
3. Stop: when the sunroof works
under automatic mode, if you touch
button A or B, the sunroof will stop
operating at once.
4. Anti-clamping in closing:
①
anti-clamping in raised opening:
During the raised closing process, if
it detects the clamping from the full
opening position to closing position,
the sunroof will go back at once.
②
Anti-clamping in non-visual closing:
During the transverse shifting
process, if it detects the clamping at
the position 4mm-200mm away
from closing position, the sunroof
will go back at once.