DFI G486VPA, User Manual, Page: 65 / 132

G486VPA
Step 2
Install the other 34-pin header connector(s) into the disk
drive(s) with the colored edge of the daisy chained
ribbon cable aligned to pin 1 of the drive edge
connector(s). The end-most connector should be at-
tached to the drive you want to be Drive A.
IDE Hard Disk Interface
The G486VPA system board is equipped with one VL-
Bus IDE connector and one ISA IDE connector that will
interface four IDE (Integrated Drive Electronics) hard
disk drives. An IDE drive is a hard drive with the
controller electronics built into the disk assembly. The
integration of the controller and the drive as a single
unit increases both the reliability and performance by
eliminating redundant circuitry.
Note:
Only IDE drives can be connected to the IDE interface.
Installation Overview
u
2-55