www.dfi.com
13
Chapter 2 Hardware Installation
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• DC-in connector
• 2 GbE (RJ-45)
• 4 USB 3.0 ports
• 1 VGA port
• 1 DP++ port
12V DC-in
DC-in
DC-in
LAN 1
LAN 2
DP
VGA
1
1
ON
2
USB 3.0
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range may fail to boot the system or cause damage to
the system board.
The 4-pin right-angle connector on the system board co-lays with a DC-in jack (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
DC-in (optional)
4-pin Vertical Type (optional)
4-pin Right Angle
(default)
1 3
2 4
GND1
GND2
12V2
12V1
