11
Chapter 2
HARDWARE INSTALLATION
User's Manual |
AL701
5. Place the cooler, i.e. heatsink or heat spreader, onto the module while making sure the
screw holes on the cooler align with the screw holes on the module. The thermal inter-
face metals underneath the cooler should also sit directly on top of the CPU and the
memory chipsets. Thermal paste shall be applied to the interfaces at this moment if it
is required.
6. Use a screw driver to fasten the screws into the screw holes. The mounting screws
may be attached to the heatsink with spings in the case of a standard package. In oth-
er cases, you may need to insert the screws that are packed separately from the cooler.
X
Assembly
Qseven Module
Qseven Socket
Key
Bracket Screw Hole
Bracket
MXM Connector
Bracket Screw Hole
Bracket Screw Hole
Bracket Screw Hole
Notch
Stand-off
Stand-off Screw Hole
Stand-off Screw Hole
Stand-off
Qseven Module
Qseven Socket
Key
Bracket Screw Hole
Bracket
MXM Connector
Bracket Screw Hole
Bracket Screw Hole
Bracket Screw Hole
Notch
Stand-off
Stand-off Screw Hole
Stand-off Screw Hole
Stand-off
X
I/O Connectors
MXM Connector
The 230-pin MXM connector (golden fingers) is used to interface with the carrier board. The pin
assignements are listed in the table below.
Pin
Assignment
Pin
Assignment
1
GND
2
GND
3
GBE_MDI3-
4
GBE_MDI2-
5
G
6
G
7
GBE_LED_100-
8
GBE_LED_1000-
9
GBE_MDI1-
10
GBE_MDI0-
11
G
12
G
13
GBE_LED_LINK-
14
GBE_LED_ACT-
15
NC
16
EC_PM_SLP_S4-
17
WAKE-
18
EC_PM_SLP_S3-
19
GPIO0_C
20
CB_PWRBTN-
21
SLP_BTN-
22
LID_BTN-
23
GND
24
GND
25
GND
26
CB_PWROK_C
