Dexter Power CSJ18LD, User Manual

Page: 15 / 36

15
EN
WARNING: Inspect work site for hidden gas pipes, water pipes, or electrical wires before
making blind or plunge cuts. Failure to do so may result in explosion, property damage,
electric shock, and/or serious personal injury.
WORKING HINTS FOR YOUR MULTI-PURPOSE SAW
If your power tool becomes too hot, set the speed to maximum and run no-load for 2-3 minutes to
cool the motor. Avoid prolonged usage at very low speeds.
GENERAL
Always use a blade suited to the material and material thickness to be cut.
Always ensure the work–piece is firmly held or clamped to prevent movement.
Any movement of the material may affect the quality of the cut. The blade cuts on the upward stroke
and may chip the uppermost surface.
Ensure your uppermost surface is a non-visible surface when your work is finished.
TROUBLESHOOTING
Symptom: The tool suddenly stops during operation.
Possible Causes:
(1) Over load
(2) Battery temperature too high
(3) Low battery capacity
Possible Solution:
(1) Relieve the load on the machine immediately and allow cooling for approx. 30 seconds at the
highest no-load speed.
(2) Charge the battery pack.
MAINTENANCE
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and will not damage your power tool.
ENVIRONMENTAL PROTECTION
This product has been marked with a symbol relating to removing electric and electronic
waste. This means that this product shall not be discarded with household waste but that it
shall be returned to a collection system which conforms to the European Directive 2012/19/
EU. It will then be recycled or dismantled in order to reduce the impact on the environment. Electric
and electronic equipment can be hazardous for the environment and for human health since they
contain hazardous substances.