Dewert User Manual 2000XL Series– Updated 05.2021/1 MDR Page 13 of 19
4.2 Technical data for electric motor
Manufacturer:
Hanning Elektro-Werke GmbH & Co, D-33813 Oerlinghausen
Type of motor:
SL 95
Type of actuator:
Brushless asynchronous industrial motor
Mode of operation:
Electromechanical linear motor with maintenance-free lifetime lubrication
Intermittent duty
– installed thermal switch
Electronic activation with internal supply for the control element
Duty cycle (DC): 25 s / 400 s
i.e. move the table for max. 25 seconds under nominal load, then observe
a break of at least 400 seconds.
Nominal voltage:
220
– 240 V, 1-50/60 Hz
Nominal consumption:
Depending on the version 850W
For model 2052XLE/2053XLE: 1700W
Current consumption:
Depending on the version 3.7A
For model 2052XLE/2053XLE: 5.0A
Protection class:
II (protective insulation), connecting cable without protective conductor
Protection rating:
IP X4
– resistant to water splashes,
Degree of protection:
B
The motor is maintenance free.
When operated with sinusoidal alternating voltage, the motors used do not cause field or line-borne interference
within the meaning of EN 50081, Part 1 and 2, nor can their function be impaired by electromagnetic influences
within the meaning of EN 50082, Part 1 and 2.
* Model 2052XLE/2053XLE is equipped with a second electric motor. Both motors are connected to the mains by
a power cable.
4.3 Technical data for hydraulic system
Manufacturer:
Power-Packer Europa B.V., NL-7575 AT Oldenzaal
Type:
Compact MK5 long
Mode of operation:
Hydraulic cylinder with pump
The hydraulic unit is maintenance free.
5. Cleaning instructions
Upholstery covering
There are two different collections of upholstery covering to choose from:
•
Skai Pandoria Plus (manufactured by Hornschuch/Continental in Germany)
•
Skai Toronto EN (manufactured by Hornschuch/Continental in Germany)
For cleaning and disinfection, a selection of agents from various manufacturers has been tested for
compatibility. Please refer to the separate enclosed sheet.
The table is equipped as standard with the
Dewert hygiene standards
, which enable optimal cleaning and
disinfection:
•
Depending on the model: Hinge lids are made of the identical upholstery covering
•
All undersides of the upholstery parts are coated with an upholstery covering and can thus be cleaned
and disinfected
•
Vent holes underneath the upholstery:
For the homogeneous foam to recover quickly, a rapid exchange of air is necessary. To ensure this, there
are individual vent points on the underside of the upholstery, which are hygienically sealed with special air
compensation caps that assume a valve function.
