Thank you for your purchase.
Please contact us if you have any problem.
Email: [email protected]
Please attach your User Name or Order ID so that
we can assist you better.
Retractable Cord Reel
HCRA40B
Instruction Manual
01
◆
Warning: To reduce the risk of fire, electric shock or personal injury, please
strictly follow the instructions.
◆
Installation
1. Do not connect any devices which may exceed the maximum ratings of
this cord reel.
2. Do not try to plug it in when your hands are wet or damp.
3. Never attempt to plug the cord reel into a non-grounded outlet.
4. When pulling the cord from the cord reel, grasp the reel’s cord itself,
but not the device or tool that the cord is plugged into.
5. Do not allow the cable to retract without restraining the retraction speed
as damage or injury may occur from excessive rewind speed.
6. Inspect before every use; do not use if parts are loose or damaged or if
insulation is worn.
7. Always unplug the retractable reel from its electrical outlet before
performing any maintenance or changing accessories.
8. Do not disassemble the body of the reel.
9. Children are not allowed to use the cord reel.
Note:
a. Check to make sure the wall or ceiling surface to which the Retractable
Reel will be mounted is sturdy enough to support the weight of the Reel
as well as the additional force when pulling on the Outlet Power Cord.
b. Drywall will not hold the weight of the cord reel. It is necessary to locate
a ceiling joist or wall stud.
1. Select a mounting location within 4 feet of an electrical outlet.
The outlet
for a garage door opener is ideal.
2. Locate a wall or ceiling beam (use a stud finder, if needed) and using the
mounting bracket as a template, mark the holes so they are centered on
the beam, see Figure1.
3. 3. Attach the mounting bracket to the beam using cement screws or wood
screw, see Figure 2.
02
Mark with a pen according to
the mounting position (Suitable
for concrete materials)
Install the bracket with
the anchor bolt and
tighten the nut
Install the bracket with
wood screws (Suitable for wood)
Mark with a pen
according to the
mounting position
(Suitable for concrete)
Drill four 45-50mm
deep holes with
10mm drill bits
Install the expansion
screws into the holes
Install the bracket with
the wood screws
(Suitable for wood)
Install the bracket
with the anchor bolt
and tighten the nut
Drill four 45-50mm deep
holes with 10mm drill bits
Install the expansion
screws into the holes
