English
3
STEP 8. Unpack rail carton and 52" Rail System table
sub-assembly carton.
STEP 9.
Assemble feet to legs.
You will need: 4 - 8mm cap head screws
4 - 8mm flat washers
4 - 8mm lock washers
4 - 8mm nuts
Place a foot over leg end as shown
(Fig. 4)
and secure
with hardware, keeping washers and nut to the inside.
If you are installing the 52" Rail System on a saw with
the Mobile Base, adjust the foot all the way down per
Figure 19. If you are not using a Mobile Base, insure
the foot is in the full up position and tighten hardware.
Repeat for remaining leg.
STEP 13.
Attach support table to left side (Fig. 7).
(If you have a Slide Table skip this step.)
You will need: 3 - 10 x 25mm hex head bolts
3 - 10mm flat washers
3 - 10mm lock washers
Without the support table in place, install the 3 bolts to
the left side with washers as shown keeping 1/4" gap.
Rest a support table on the bolts, fitting into the notch-
es. Using the extruded fence face as a straightedge,
flush the support table to the saw table edge and snug
the front bolt. Repeat this process for the rear bolt and
the center bolt. Tighten hardware.
STEP 11.
Assemble leveling hardware to table (Fig. 5).
You will need: 2 - 10 x 80mm flat head bolts
2 - 10mm lock washers
2 - 10mm jam nuts
Place flat head bolts through table from the top side.
Secure each bolt with a lock washer and nut.
Tighten hardware, be careful not to damage the board
by over-tightening.
STEP 10.
Assemble leg set.
You will need: 8 - 8mm cap head screws
8 - 8mm flat washers
8 - 8mm lock washers
8 - 8mm nuts
Assemble legs to support pan
(Fig. 4)
using eight M8
cap head screws. Insure that the square holes in the
support pan are oriented closest to the feet end of the
legs. Secure each bolt with a flat washer, lock washer,
and nut, keeping the washers and nuts to the inside.
Tighten hardware.
STEP 12.
Attach leg set to table sub-assembly.
You will need: 2 - 8mm cap head screws
2 - 8mm flat washers
2 - 8mm lock washers
2 - 8mm nuts
4 - 10mm flat washers
2 - 10mm lock washers
4 - 10mm jam nuts
Place the table on the floor, flat side down. Add an M10
jam nut and a flat washer to each leveling bolt
(Fig. 5)
and run nuts to within 6.4mm (or 1/4") of previously
added jam nut. Place leg set, facing outward, over lev-
eling bolts. Leg set is not yet secure, steady it while
you add a flat washer, lock washer, and a jam nut to
each bolt and tighten, snug only. Add an M8 cap head
screw through the open ended slot in each side rail and
the square hole in the legs. Secure each bolt with a
flat washer, lock washer, and nut, keeping the washers
and nut to the inside of the leg
(Fig. 6)
. Finger tighten.
FIG. 4
FIG. 5
FIG. 6
FIG. 7
6.4 MM
1/4”
6.4 MM
1/4”
Summary of Contents for DW7464
Page 1: ...1 ...
