ENGLISH
28
Battery Indicator
As the battery nears a fully discharged state, the
flashlight will blink twice and then the brightness of
the light will drop below the normal level. This cycle
will repeat until the battery is fully discharged.
Pivoting Head (fi g. 1)
The pivoting head rotates in nine positions ranging
from 0°–144°.
Carrying and Suspending the Light
(fi g. 1, 4)
CAUTION:
When light hangs by the
belt hook or hang hook, do not shake
the light or the object from which it
hangs. Do not hang the light from any
electrical wires or anything that is not
secure. Personal injury or property
damage may occur.
CAUTION:
Only use the belt hook or
the hang hook for hanging the LED
worklight. The belt hook and hang hook
are not intended to support additional
weight. Do not attach or hang anything
additional to the light or risk of breakage
may occur.
CAUTION:
Do not use the belt hook
or loop to reach with or to support your
weight in any situation.
HANG HOOK (FIG. 1, 4)
The telescopic hang hook (b) extends out of the
pivoting head (c). The hang hook locks into place
when fully collapsed or when fully extended, as
shown in Figure 4. The hook rotates 360 degrees.
MAINTENANCE
Your D
E
WALT worklight has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Cleaning
WARNING:
Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING:
Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING:
Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING:
Since accessories, other
than those offered by D
E
WALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
E
WALT, recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
BELT HOOK (OPTIONAL ACCESSORY, FIG. 5)
WARNING:
To reduce the risk of
serious personal injury, ensure the screw
holding the belt hook is secure.
IMPORTANT:
When attaching or replacing the belt
hook (h), use only the screw (g) that is provided. Be
sure to securely tighten screw.
The belt hook (h) can be be attached to either side
of the light using only the screw (g) provided, to
accommodate left- or right-handed users. If the
hook is not desired at all, it can be removed from
the light.
Summary of Contents for DCL050
Page 1: ...DCL050 ...
Page 3: ...1 Figure 1 Figure 2 b c e a d f d e Figure 3 ...
Page 4: ...2 b Figure 4 g h Figure 5 ...
