3
Important Charging Notes
1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 65°F and 75°F
(18°- 24°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will
prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To
facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an
uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp or other appliance;
b. Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights;
c. Move charger and battery pack to a location where the surrounding air temperature is approximately 65°F - 75°F (18°- 24°C);
d. If charging problems persist, take the tool, battery pack and charger to your local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE
to use under these conditions. Follow the charging procedure. You may also charge a partially used pack whenever you desire with no adverse
affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, grinding dust, metal chips, steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in
the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Don’t allow any liquid to get inside charger. Electric shock may result.
CAUTION: Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service
center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.
2. Long storage will not harm the battery pack or charger. Under proper conditions, they can be stored for 5 years or more.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect battery pack before making any adjustments or removing/
installing attachments or accessories.
Installing and Removing the Battery Pack (Fig. 2)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (A) into the tool, align the battery with the rails and slide it firmly into the unit until you hear the lock snap into place.
To remove the battery pack from the tool, press the release the button and firmly pull the battery pack out of the tool. Insert it into the charger as
shown in Fig 1a,1b.
Operating Tips
• The D
e
WALT lithium ion battery can be used with your Red or with the Green Li Ion Lasers to ensure enhanced life.
• Ensure batteries are in good working condition. If the low battery indicator light on the laser is flashing, the batteries need
to be recharged.
MAINTENANCE
WARNING:
To reduce the risk of serious personal injury, turn tool off and disconnect battery pack before making any adjustments or
removing/installing attachments or accessories.
Cleaning
WARNING:
Never use solvents or other harsh chemicals for cleaning the tool. These chemicals may weaken the plastic materials used in
these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING:
Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from the exterior
of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Accessories
WARNING:
Since accessories, other than those offered by D
e
WALT, have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only D
e
WALT, recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance
in locating any accessory, please contact D
e
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-D
e
WALT
(1-800-433-9258) or visit our website www.dewalt.com.
