DeWalt D25961-XE, Instruction Manual

Page: 7 / 12

5
ASSEMBLY AND ADJUSTMENT
WARNING: Prior to assembly and adjustment always unplug the tool.
WARNING: Always wear gloves when changing accessories. The exposed metal
parts on the tool and accessory may become extremely hot during operation.
WARNING: Since accessories, other than those offered by D
E
WALT, have not
been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
E
WALT, recommended accessories
should be used with this product.
NOTICE: To reduce dust contamination in the tool, keep dust and debris away from
the bit and the beat piece.
Inserting and Removing 30 mm
FIG. 2
(1-1/4") Hex Accessories
(Fig. 2, 3)
This machine uses chisels with a 30 mm
(1-1/4") hex shank.
Clean the chisel shank (Fig. 2).
TO FIT A CHISEL WITH GROOVE IN THE
SHANK (FIG. 3)
1. Pull the retainer
G
E
H
FIG. 3
30 mm
(1-1/4")
D
bolt (G) and turn it
by 180° to the
unlock position.
2. Hold the chisel in
front of the tool
holder with the
groove (H) facing
upwards.
3. Insert the chisel
shank into the tool
holder (E).
4. Pull the retainer bolt
(G) and turn it by
180° back to the
lock position.
5. Pull on the chisel to check if it is properly locked. The hammering function
requires the chisel to be able to move axially several centimeters when locked
in the tool holder.
6. To remove a chisel pull the retainer bolt (G) and turn it by 180° to the unlock
position.
Adjusting the Side Handle (Fig. 1)
WARNING: Always operate the machine with the side handle properly mounted.
The side handle (F) is assembled on the machine to suit both right- and left-hand
users
1. Loosen the clamp knob (C) and rotate the side handle to the desired position.
2. Lock the side handle in place by tightening the clamp knob (C). Ensure side
handle is secure and does not rotate.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: Be aware of the location of pipework and wiring.
WARNING: Apply a pressure of approx. 20–30 kg. (44–66 lbs.) to the tool.
Excessive force does not speed up chiselling but decreases tool performance and
may shorten tool life.
Proper Hand Position (Fig. 4)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely
in anticipation of a sudden reaction.
IMPORTANT: The tool must be held with two hands at all times when in use.
HORIZONTAL APPLICATIONS (FIG. 4A)
Proper hand position requires one hand on the side handle (F) and the other hand
on the main handle (B).
VERTICAL APPLICATIONS (FIG. 4B)
Proper hand position requires both hands on the main handle (B).