Page 12 of 63
q
Fit nut to threaded rod and tighten until the washer (89) is just clear of
the Snap Ring (86).
Be careful not to over tighten.
q
Using circlip pliers and a small flat bladed screwdriver prise
the Snap Ring from the groove then maneuver it past the large
groove to clear the Spindle
q
Remove the nut and the Three Legged part from the Jig.
q
Remove the Snap Ring. (
Do Not re-use
).
q
Lift off the Sliding Sleeve Assembly
q
Remove the Washer (89) (
Do Not re-use
), Remove Rubber Ring (90)
and Locking Ring (92).