28
ENGLISH
ROTARY DRILLING MODE
Use rotary drilling mode for wood, metal,
and plastics.
HAMMERDRILL MODE
Use this mode for masonry drilling.
Depth Rod (fi g. 6)
TO ADJUST THE DEPTH ROD
1. Push in and hold the depth rod release
button (h) on the side handle.
2. Move the depth rod (d) so the distance between
the end of the rod and the end of the bit equals
the desired drilling depth.
3. Release the button to lock rod into position.
When drilling with the depth rod, stop when end
of rod reaches surface of material.
OPERATION
Instructions for Use
WARNING:
Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Trigger Switch (fi g. 1)
To start the sub-compact hammer, depress the
trigger switch (a). To stop the hammer, release the
switch.
NOTE:
Use lower speeds for starting holes without
a centerpunch, drilling in metal, plastics or ceramics.
Higher speeds are better for drilling in masonry for
maximum efficiency.
VARIABLE SPEED
The variable speed trigger switch (a) permits speed
control. The farther the trigger switch is depressed,
the higher the speed of the drill.
Proper Hand Position (fi g. 7)
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
use
proper hand position as shown.
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
hold
TO ADJUST THE SIDE HANDLE
1. Loosen the side handle (c) by turning it
counterclockwise.
2. Rotate the side handle to the desired position.
3. Tighten the side handle by turning it clockwise.
TO CHANGE SIDES
For right-hand users:
slide the side handle
clamp over the chuck, handle at the left.
For left-hand users:
slide the side handle clamp
over the chuck, handle at the right.
SIDE HANDLE WORK LIGHT (D25052KT ONLY) (FIG. 3)
Your side handle has a work light. The light is battery
powered and operated by using the on/off button (i).
To replace the worklight's batteries (CR2032 x 2):
1. Remove battery door screw (j) as shown in
fig. 3.
2. Replace the battery with the positive face
pointing outwards.
3. Close the battery compartment and secure the
screw.
Reversing Lever (fi g. 4)
The reversing lever (g) is used to reverse the
sub-compact hammer for backing out fasteners or
jammed bits in the drill-only function.
CAUTION:
When reversing to clear
jammed bits, be ready for strong
reactive torque.
To reverse the sub-compact hammer, turn it off and
align the reversing lever (g) with the yellow arrow
pointing backward.
To position the lever for forward operation, turn the
sub-compact hammer off and align the reversing
lever (g) with the yellow arrow pointing forward.
Mode Selection Collar (fi g. 1, 5)
NOTICE:
Tool must come to a
complete stop before activating the
mode selector button or damage to the
tool may result.
To switch the tool from the drilling mode to the
hammering mode (or vice-versa) rotate the collar (f)
to the applicable symbol.
Turn the collar (f) to the drill bit symbol for drilling or
to the hammer symbol for hammerdrilling.
NOTE:
The arrow on the mode selection collar
MUST
be aligned with one of the symbols at all
times. There are no operable positions between the
positions.
