Develop ineo 250, Service Manual Field, Page: 534 / 770

Field Service Ver. 1.0 Aug. 2005 12. Troubleshooting
165
FK-503
T
roubleshooting
12.2.4 Communication errors (RX)
Code Description Cause Remedy
Re Li Lo
33 • Protocol failure in V.34
sequence
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try another line.
91 • T1 timeout while waiting
for initial identification sig-
nal
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try another line.
92 • Received DCN while wait-
ing for commands other
than DCN in phase B
Interruption or failure
in remote machine
|
Check the status of the
remote machine and retry TX.
95 • Detected low speed flag
followed by 10 sec. time-
out while waiting for detec-
tion of image signal carrier
(HMCD ON)
Failure in remote
machine
|
Try another remote system.
Line failure
|
Try another line.
96 • Carrier disconnected for
15 seconds while receiv-
ing G3 image signal
Error in remote
machine
|
Ask for resending.
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try another line.
97 • T2 timeout while waiting
for post message
• T2 timeout while waiting
for DCN after receiving
last page
• No response from remote
system after changing
mode (T2 timeout)
Error in remote
machine
|
Try another remote machine.
Accidental RTC detec-
tion (line failure)
|
Try another line.
98 • Received DCN while wait-
ing for command other
than DCN in phase D
Interruption or failure
in remote machine
|
Ask for resending.
99 • Received PRI-Q as post
message (Communica-
tion is regarded as nor-
mal even with error
message)
Failure in remote
machine
|
Check the status of the
remote machine.
9A • Cannot decode line cor-
rectly for 35 seconds while
receiving ECM image sig-
nal
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try another line.
Failure in FAX board
|
Replace FAX board
Failure in MFBS board
|
Replace MFBS board
9C • Received CRP 3 times
while waiting for initial
identification signal
Failure in remote
machine
|
Try another remote machine.
Failure in FAX board
|
Replace FAX board
Failure in MFBS board
|
Replace MFBS board
Line failure
|
Try another line.