Develop ineo 250, Service Manual Field, Page: 532 / 770

Field Service Ver. 1.0 Aug. 2005 12. Troubleshooting
163
FK-503
T
roubleshooting
12.2.2 Terminal alarm
12.2.3 Communication errors (TX)
Code Description Cause Remedy
Re Li Lo
45 • Memory overflow or nearly
full
Memory overflows or
nearly full
|
Reset the terminal alarm and
ask the remote end for
resending.
46 • Document jamming Feeding is not working
continuously.
|
Reload a document.
Jamming in a long
document or in the
middle of a page
(Feeding is not com-
pleted even if feeding
exceeds 1 m.)
|
Reload a document.
47 • “No print paper” or “Side
cover opened” were
detected
Out of print paper
|
Load print paper.
Side cover was
opened while RX
|
Close the side cover.
Code Description Cause Remedy
Re Li Lo
33 • Protocol failure in V.34
sequence
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try another line.
70 • Busy tone while waiting for
initial identification signal
• Timeout or modem failure
while detecting 2nd dialing
tone
• Cannot dial due to dialing/
ringing conflict
• T1 timeout while waiting
for initial identification sig-
nal when FAX signal is not
detected
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try another line.
71 • T1 timeout while waiting
for initial identification sig-
nal after FAX signal is
detected
• Detected reverse polarity
while waiting for initial
identification signal
Failure in remote
machine
|
Try another remote machine.
Line failure
|
Try BACK to BACK commu-
nication.
72 • Received DCN in phase B
while waiting for com-
mands other than DCN
Interruption or failure
in remote machine
|
Check the remote system
and retry TX.