Develop ineo+ 25, User Manual

Page: 195 / 340

Scanning With the Machine 7-17
Searching an LDAP Server
The destination e-mail address where the scan data is to be sent can be
specified by using information on the LDAP server.
d
To connect to an LDAP server, settings for [LDAP SETTING] must be
specified. For details, refer to the [Reference Guide] on the Documen-
tation CD/DVD.
d
A maximum of 16 addresses (total of addresses from direct input and
an LDAP search) can be specified.
d
If anonymous access is used to search for information on an LDAP
server, the correct search results may not be retrieved.
1
With the main screen (Scan mode) or [Can Use AddressBook] displayed,
press the
Addressbook key four times so that [ADDRESS BOOK]
appears.
2
Press the + or , key to select [LDAP SEARCH], and then press the
Select
key.
3
Press the + or , key to select [NAME] or [E-MAIL], and then press the
Select
key.
d
To search registered names, select [NAME]. To search e-mail
addresses, select [E-MAIL].
4
Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the
Select key.
The search begins, and the search results appear after a while. If no data
matches the search keyword, [NOT FOUND] appears for about two sec-
onds.
d
For details on entering/editing text, refer to “Entering Text” on
page 12-8.
d
Text starting with the first character of the maximum 10 charac-
ters is searched for. Text will not be found if the search keyword is
in the middle of a word.
5
Press the + or , key to select the desired data, and then press the
Select key.
d
To check the found information, press the
)
key.
d
An e-mail address exceeding 64 characters cannot be specified. If
such an e-mail address is specified, [ADDRESS IS TOO LONG]
appears for about two seconds, and then the screen for specify-
ing the destination address appears.