FrameMaker Ver5.5E(PC) Di152/Di183 SWITCHES ON PWBs/TECH. REP. SETTINGS
01.07.26
S-25
4.
SECURITY MODE
• Allows the Tech. Rep. to set the various counters.
4-1.
Settings in the Security Mode
4-2.
Security Mode Setting Procedure
<Procedure>
1. Set the machine into the Tech. Rep. Mode.
2. Press the following keys in this order:
Stop
→
9 (Display: SCU).
3. Enter the code number corresponding to the subfunction to be used.
Code No.: 1 to 4
4. Press the Start key to display the current setting value.
5. Press the Clear key to clear the current setting value.
6. Enter the new setting value from the 10-Key Pad.
7. Press the Start key to validate the new setting value just entered.
If any value outside the available setting range is entered, the Display shows “Err”
rejecting the entry. (The old setting value will reappear on the Display 1 sec. later.)
<Exiting the Mode>
• Press the Panel Reset key until the initial screen reappears.
Code No.
Description
--1
Total Counter Count Mode
--2
Size Counter Count Mode
--3
Key Counter
--4
Total Counter
Summary of Contents for D1531iD
