User Manual DEV 5072
24
Copyright DEV Systemtechnik GmbH 2016-2017
It is recommended to change the password of the factory default ADMIN
account (chapter 5.4.6.1.2).
The language of the screenshots shown here is English, as a second language
currently German is available (chapter 5.4.6.1.2).
5.4.2
The Main Window and Common Features of the Main Tabs
After successful authentication the main window of the Web Interface shows up
with the Status Tab opened, which is the default view:
In the top of the window on the left side, the five tabs are located ("Status",
"Control", "Events", "Setup", and "Info"). The active tab is highlighted; clicking on
an inactive tab opens the corresponding tab instead.
In the middle on the top of the window two buttons are located indicating that the
device is either in Remote Mode (as shown in the screenshot above) or in
Local Mode (as shown in the screenshot of chapter 5.4.3).
Changing the operation mode of the device via Web Interface is performed by
clicking on the desired button, e.g. clicking in the situation above on the
button highlights the
button instead of the
button.
Right to these buttons the currently logged in user (here: "ADMIN") and the permis-
sion of the user (here: "admin") are shown. Please refer to chapter 5.4.6.1.3 for
more information on this subject.
Then, the date and time of the device are displayed right to this information. The
correct date and time depend on the proper configuration of an NTP timeserver
and of the timezone (chapter 5.4.6.2.1). Note that if there was no timeserver
