User Manual DEV 5072
Copyright DEV Systemtechnik GmbH 2016-2017
19
4.4.2.2.1
Start and Termination of the Configuration Program
In this application the serial interface is exclusively used for the configuration pro-
gram, i.e. if the terminal application is started (and connected) either the following
text is displayed initially or after hitting the "Enter" or "
" key on the keyboard:
DEV login:
With the following authentication the configuration program is started:
DEV login:
config
<CR>
Password:
devConfig
<CR>
Note:
<CR>
stands for hitting the "Enter" or "
" key on the keyboard.
All characters/commands to be entered are case sensitive.
After successful authentication, the configuration program is launched. After start
and after the finalization of most of the choices the program lists the choices that
can be performed:
config
======
1 set IP address (192.168.0.225)
2 set netmask (255.255.0.0)
3 set gateway (192.168.0.99)
q quit without saving
x save configuration and exit
your choice >
Choices can be executed by typing the character in the first column of each line
followed by a
<CR>
. The second column of each line provides a short description of
the choice and the third column displays in parentheses the current setting of the
corresponding choice. In the example above, the IP address and the netmask are
different from the factory network settings (please refer to chapter 4.3.2).
When using the "
q
" choice the configuration
program terminates and the login
message is displayed again:
DEV login:
When using the "
x
" choice the configuration
program saves all changes made and
resets the device (i.e.
rebooting the device
):
your choice >
x
<CR>
rebooting the device, please wait...
Again, during a reset the device still delivers output voltage, i.e. the power supply
module outputs are not deactivated while resetting the device.
After a device reset it takes a few moments before the serial interface is accessible
again as described at the beginning of this chapter.
In the following, the available choices are explained:
