24.5.04
Instruction manual LOCON 7, LOCON 9 V. 10.4
33
Deutschmann Automation GmbH & Co. KG
Programming LOCON 7 and LOCON 9
By repeatedly pressing the key
counterclockwise, the operator gets all programmed cams
displayed, or he can move forward by a repeated pressing of
or
and the display
changes between the switch-on- or the switch-off-point, that is displayed by the LEDs "On" and
"Off".
After displaying the cam with the highest encoder value, the first cam follows again or vice versa,
but a blank cam is added in between, because it is necessary for programming new cams, that is
described later on.
7.9
Changing existing cams
Should an existing cam be changed, the cam which is to change must be displayed, as it is
described in the previous chapters.
After that it is changed to the programming mode by pressing the key
(long).
Then the LEDs "Prg.Mode" and "On" or "Off" flash depending if the switch-on- or the switch-off-
point of a cam is programmed.
With the keys
and
the desired value can be adjusted. The keys have a graduated
autorepeat-function; i. e. the longer the key is pressed, the faster the value of the display
increases or decreases.
If the right value is adjusted, it can be taken over with
or rejected again with
. This auto-
matically leads back to the display mode.
If the value is taken over, the display changes to the next value. That is either the switch-on point
of the next cam, if an switch-off point has been programmed, or the switch-off point of the same
cam, if an switch-on point has been programmed.
If the change was carried out in the active program, it immediately affects the other outputs.
If no other cams are to be changed, you can return to the display mode with
.
7.10 Deleting existing cams
Deleting a cam is the same procedure as changing it, only that the switch-on point is pro-
grammed like the switch-off point or vice versa.
If LOCON recognizes that the switch-on- or the switch-off-point are identical, the cam is removed
from the program.
7.11 New programming of cams
At first the new programming of a cam is the same procedure as changing it. Always when a
blank cam appears on the display, the possibility of a new programming is given by changing
with
(long) into the programming mode. Now as many cams as desired can be completed in
the selected program and output. The program expects the switch-on point at first and then the
switch-off point, that is marked by the flashing LEDs "On" or "Off".
The input of the values is carried out analogous to the procedure of changing the cams.
If no more cams are to be completed, it is possible to return to the display mode with the
-
key.