EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE
26.3 INSTALLATION OF THE OIL COOLANT MODULE
Install as follows:
1. Install thermostat to oil coolant module with four bolts. Torque to 20-25 N·m (15-19 lb·ft).
2. Install Exhaust Manifold Guide Studs tool (J–36107) into the cylinder block to assist in
guiding the oil coolant module onto the cylinder block.
3. Install new gasket.
4. Install the oil coolant module onto the guide studs and cylinder block.
5. Install eleven bolts and torque to the following:
□
10 N·m (7 lb·ft)
□
Final torque the bolts to 60-65 N·m (44-47 lb·ft)
6. Remove tool (J–36107). Install the remaining two bolts into the oil cooler module. Torque
the bolts to the following:
□
10 N·m (7 lb·ft)
□
Final torque the bolts to 60-65 N·m (44-47 lb·ft)
7. Install the dipstick tube and two bolts and torque to 15 N·m (11 lb·ft).
8. Install the radiator support strut bracket. Torque to 100 N·m (74 lb·ft).
9. Install water pump if removed. Refer to section 29.4.
10. Install poly-V-belt to water pump pulley. Refer to section 40.3.
11. Install electrical engine harness to the sensor.
12. Connect coolant line to fuel module and oil coolant module.
13. Install heater hose to oil coolant module.
All information subject to change without notice.
DDC-SVC-MAN-0081 2010
Copyright © 2010 DETROIT DIESEL CORPORATION
26-7
Summary of Contents for EPA07
Page 1: ......
Page 2: ......
Page 287: ...23 OIL FILTER Section Page 23 1 REPLACEMENT OF THE OIL FILTER 23 3 ...
