DETEWE OpenCom 510, User Manual

Page: 12 / 164

10
Telephony Functions Factory Settings
Factory Settings
The OpenCom 510 is delivered with
the following basic settings and acti-
vated features. We recommend that
you configure the OpenCom 510 to
meet your specific requirements be-
fore putting it into operation (see
Configuration starting on page 70).
Tip: Notes on the functions listed
below can be found in the glossary
(provided as a PDF file on the system
CD-ROM).
Telephony Functions
■
The OpenCom 510 is pre-config-
ured for use in Germany.
■
Analogue terminals: The dial-
ling mode (pulse dialling or
DTMF) is detected automatically.
■
Incoming external calls are sig-
nalled at all corded terminals
connected to the system.
■
The system PIN, which is used
for remote-programmable call
forwarding, for example, is
“0000”.
Authorisations
Authorisations determine which
functions can be used at the
terminals connected to the
OpenCom 510. Authorisations are
configured for so-called user groups;
users and their terminals are allo-
cated to these groups.
Two user groups are preset: “Admin-
istrators” and “Guests”. “Administra-
tors” have access to all functions of
the OpenCom 510 and unrestricted
configuration rights. Users in the
“Guests” group cannot configure the
OpenCom 510 or make external
calls, and have only restricted use of
the terminal functions of the
OpenCom 510.
Note: When the OpenCom 510 is
first put into operation, all connected
terminals are in the “Administrators”