DeTech
1
GateWL REV: 02/08/2018
GATE WL
Double tented technology via
bidirectional radio
Gate WL is a double tented technology sensor, with a 140° x
15° coverage. Ideal for the protection of gaps, doors,
windows, corridors and balconies.
Caratteristiche tecniche
➢
Absorption at rest: 26 uA.
➢
Installation height: up to 4 m.
➢
Adjustable range.
➢
Adjustable relevation sensibility.
➢
Microstrip microwave 10.525 gHz.
➢
Flicker-free board
➢
Sealed optical.
➢
140° x 15° for 4 m coverage
➢
Power supply: 3,6v- n.1 lithium battery ,3v6 mod. ER14505
cabled AA 2,4Ah.
➢
3 years of life (at standard use)
➢
Radio Freq.868MHz-FM.
➢
Encrypted code.
➢
Anti tampering protection.
➢
Radio supervision.
➢
Visual indication of low battery
➢
Selectable detection circuit.
!
WARNING: Before every trial, connect the
sensor to the receiver
1.
Installation guide
Gate WL è is designed to protect gaps like corridors,
windows and balconies. It has to be placed horizontally in
the middle and on the highest area of the place you need
protection on.
Remove the upper lid, remove the board pushing on the finger,
carve the preprinted holes on the bottom and secure it with the
screws and the pieces to protect with the lens pointing
downwards. Do not point the sensor upwards. Its coverage in
width is twice its installation height.. Ex: if placed in the middle
of a window 1m tall, its coverage in width will 2 m.
2.BATTERY INSERTION
Remove the board and connect the
battery to the circuit through the connector, positioned on the
back of the board and put it in the battery carrier on the D
bottom. Wait 2 minutes for the auto-calibration. The GREEN and
RED LEDs will blink alternatively
3. ACQUISITION
The acquisition of the sensor in the system
takes place when a Tamper alarm is generated (by releasing the
Tamper button)
or setting the battery in “acquisition” mode
.
4RADIO COVERAGE TEST
When the battery is disconnected,
push the Tamper button and connectthe battery. When the LED
will blink, drop the Tamper button. The GREEN LED suggests a
good signaling, when the GREEN and RED LEDs blink, the wireless
signal is not fit, with no blinking the signal is absent. To end the
Test, push the Tamper or wait for 4 minutes.
5.
ADJUSTMENT
Adjust the range of the microwave through the dedicated
trimmer. Select, if necessary, the high sensitivity relevation
mode for open gaps that can be crossed on the run ( sens jumper
inserted) To disable, if requested, the LED display,insert the LED
jumper. Close the lid, hooking it on the battery side, and closing
it with a screw. Once the lid is closed, the TAMPER will activate;
The validation of the correct closure of the tamper is given by an
alternating blinking (lasting for a couple of seconds) of the
GREEN and RED LEDs. Repeat this operation if necessary.
!
WARNING: Before every trial, connect the
sensor to the receiver
6. WALK TEST
Antenna
Finger
Tamper
Trimmer regulation MW
