Se nti
nel C X T
Sentinel CXT Instruction Manual
Rev. 1.7
Page 28 of 49
4. Swipe over the ENTER marker to return to the flashing cursor.
R L 4B a nk C ount
The RL4 Bank Count value can be 1, 2, 3, 4, 5, 6, 7, or 8and defines the total number of banks that the
channels have been assigned. When selected, a new page allows the user to toggle the channelꞌs relay bank
assignments for all eight banks.
1. Swipe the ENTER marker to change the number of banks assigned to the channel. When ENTER is
swiped, the RL4 BANK ASSIGNMENT menu is displayed:
R L 4B A N K A SSIG N M EN T
[1]
2
3
4
5
6
7
8
2. The brackets [x] indicate the bank that is selected. Use the down arrow to change the bank
selection. Swiping the up arrow enables or disables the alarm bank. If the bank number is shown,
then the alarm bank is enabled. If “—“ is shown, then the bank is disabled
3. Swipe ENTER to save and exit
4. Swipe MENU to exit without saving
Swipe the down arrow marker while the flashing cursor is on RL4 BANK CNT to scroll the display to the
next channel allowing for its configuration.
A swipe of the up arrow marker while the flashing cursor is on SLAVE ID will return to the previous
channel.
5.4.3 SetC ha nnel A la rm s
The Set Channel Alarms menu allows configuration of each channel’s alarms. The information to be
configured is the;
AL M 1 L EVEL ,
AL M 1 AS CEN DIN G,
AL M 2 L EVEL ,
AL M 2 AS CEN DIN G,
AL M 3 L EVEL ,and
AL M 3 AS CEN DIN G.
1. Upon entering this menu, the LCD will display:
C H A N N EL 1A L A R M S:
A L M 2L EV EL :
##
A L M 2A SC EN D IN G :X
A L M 1L EV EL :
##
A L M 3L EV EL :
##
A L M 1A SC EN D IN G :X
A L M 3A SC EN D IN G :X
2. A flashing cursor will appear on ALM1 LEVEL. Swiping the magnet over:
T hem arkersoftheupordow narrow sw illm ovetheflashingcursortothedesiredfunction.
T heEN T ER m arkerw illselectthefunctionindicatedby theflashingcursor
T hem arkersoftheupordow narrow sw illchangethevalue.
T heEN T ER m arkerw illsavetheselectedvalueandreturntotheflashingcursor.
