26
•
Divide your hair into individual strands with a
width of about 3 cm. Hold the strands taut and
place them between the straightening iron [G] at
the roots.
•
Move the straightener slowly and smoothly from
the roots to the ends. Do not keep the straigh-
tener at any one place for longer than 8 to 10
seconds. This way you will obtain the best results
without overstraining or damaging your hair.
•
You can shape the ends by twisting the straighte-
ner either outward or inward before you pull it out
over the ends.
Using the crimping iron
•
Attach the straightening/crimping attachment [12]
to the multi-function styler.
•
Slide the selector switch [11] into the „Crimp“ po-
sition [c]. Now the crimping iron [F] can be used.
•
Divide your hair into individual strands. Hold
the strands taut and place them between the
crimping iron [F] at the roots.
•
Close the crimping iron [F] for about 10 seconds.
This way you will obtain the best results without
overstraining or damaging your hair.
•
Open the crimping iron [F] again and take the hair
strands out.
•
Repeat the process until you have reached the
hair ends.
After use
•
Switch off the unit by moving the slide switch [5]
into position 0.
•
Place the multi-function styler with the stand
down onto a stable, horizontal and non combus-
tible surface or hold the multi function styler in
your hand to let it cool.
•
Remove the plug from the socket after each use.
•
Do not wind the mains cable [9] around the unit!
•
Store the unit in a dry place that is out of reach of
children.
•
The unit can be hung on a hook by the hanging
eyelet [8].
7. Cleaning and care of the unit
Notes
•
Your unit is maintenance-free.
•
Protect the unit from dust, dirt and moisture.
Cleaning
Important
•
Always remove the plug from the socket before
cleaning.
•
Ensure that no water enters the inside of the unit!
•
Do not wash the unit in a dishwasher!
•
Do not use any strong, sharp, abrasive, corrosive
cleaning agents or hard brushes!
•
Do not clean it with any highly flammable liquids!
•
The unit and the attachments can be cleaned
with a soft cloth that has been moistened with
warm water.
•
Dry the unit and the attachments carefully after
cleaning them!
Cleaning the straightening/crimping
iron [F/G]
•
Slide the selector switch [11] into the „Straighten“
position [a].
•
Press on the lever [3] to open the straightening/
crimping attachment [12].
•
Use the fingers on your other hand to slide the
selector switch [11] into the „Crimp“ position
[c]. Now the straightening/crimping iron [F, G] is
unlocked.
•
Remove the straightening/crimping iron [F, G]
from the straightening/crimping attachment [12].
Summary of Contents for HC 40
Page 47: ...47...
