Desco 60509, Installation, Operation And Maintenance

Page: 1 / 3

DESCO WEST - 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website: Desco.com
TB-3059 Page 1 of 3
© 2020 DESCO INDUSTRIES INC
Employee Owned
Ionizer Motion Sensor
Installation, Operation and Maintenance
Description
The Desco 60509 Ionizer Motion Sensor is designed
to automatically activate an ionizer when an operator
is present at a workstation and turn off when the
workstation is vacant. This product ensures that the
ionizer is activated when required. It also conserves
energy and increases maintenance intervals of the
ionizer by deactivating it when the workstation is vacant.
The Control Unit is capable of switching up to 5 amps at
120VAC and is fuse protected.
The Ionizer Motion Sensor consists of two components:
the Sensor Unit and Control Unit. The control unit
connects between the AC power cord and the ionizer
power input using standard IEC type (C13/C14)
connectors. The sensor unit is placed in a position
to “detect” an operator up to three feet away. The
sensitivity levels can be adjusted to: low (12 inches),
medium (24 inches) or high (36 inches). The Sensor
Unit should be mounted flush with the front edge of the
mounting surface whenever possible. This is done to
prevent reflected light from the mounting surface. The
two components communicate using a standard 6-pin
modular cable.
The Ionizer Motion Sensor utilizes a unique infrared
light and band pass filter to prevent interference from
other light sources. The band pass filter uses a reflected
infrared light with the specific frequency to sense the
presence of the operator. It does not require continuous
motion to remain activated. The deactivation delay
time can be set to 1 minute, 10 minutes or 1 hour
periods. This delay prevents the ionizer from turning on
and off frequently if an operator is only away from the
workstation momentarily.
May 2020
Figure 1. Desco 60509 Ionizer Motion Sensor
The Ionizer Motion Sensor is compatible with the
following Desco ionizers:
Item Description
50663 Benchtop Zero Volt Ionizer, Stainless Steel,
120VAC
50690 Benchtop Zero Volt Ionizer, Powder Coat,
120VAC
60505 High Output Benchtop Ionizer, 120VAC
50664 Overhead Zero Volt Ionizer, 2-Fan, 120VAC
50665 Overhead Zero Volt Ionizer, 3-Fan, 120VAC
60640 Chargebuster® Overhead Ionizer, 2-Fan,
120VAC
60473 Chargebuster® Overhead Ionizer, 3-Fan,
120VAC
60467 Chargebuster® Overhead Ionizer with Lights,
2-Fan, 120VAC
60468 Chargebuster® Overhead Ionizer with Lights,
3-Fan, 120VAC
Packaging
1 Sensor Unit
1 Control Unit, 120VAC
1 Modular Cable, 2'
1 Modular Cable, 7'
2 Hook and Loop Fastener Strips
2 Screws
TECHNICAL BULLETIN TB-3059
Made in the
United States of America