![background image](http://html.mh-extra.com/html/desa/svyd18nr-series/svyd18nr-series_owners-operation-and-installation-manual_2485947009.webp)
111162-01A
9
9
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Figure 10 - Attaching Stove Bottom (Amity™ Model Shown)
Bottom Of
Stove Unit
Bolt
Washers
Stove
Bottom
Figure 11 - Attaching Stove Legs (Sheraton™ Model)
Leg
Bolt
Figure 12 - Attaching Stove Bottom (Sheraton™ Model)
Bottom Of
Stove Unit
INSTALLATION
Continued
Bolt
Washers
Stove Bottom
Bottom Of
Stove Unit
Figure 13 - Attaching Stove Door (Appearance May Vary
Depending on Model)
Stove
Bottom
10. Attach stove door by inserting step bolt through door hinge pivot
hole and into threaded hole in stove body (see Figure 8, page 8 and
Figure 13). Use an adjustable wrench or a 12mm socket to fasten
step bolt. Tighten step bolt until snug. Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 8, page 9).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 14). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make
final adjustment and door leveling after stove is in normal
standing position.
13. Carefully lift stove back up on its four attached legs.
14. Set top grate into stove top.
15. If available, install gas log heater inside stove cavity before
installing the back panel (see Installing Gas Log Heater Into
Stove, page 10).
16. Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts
and washers. Make sure product identification label is located
on the outside in lower left-hand corner.
Sheraton™ Models
8.
Fasten each leg to stove with four (4) bolts. Use a flat screw
driver to tighten bolt to leg. Insert bolt in threaded holes on
stove body (see Figure 8, page 8, and Figure 11).
9.
Fasten stove bottom to stove with four (4) M6 x 1 - 25mm
bolts. Use a flat washer and lock washer with each bolt. Tighten
bolts into threaded holes on stove body (see Figure 8, page 8,
and Figure 12). Use an adjustable wrench or a 10mm socket.
Step Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Bolt Shoulder
Door
Hinge
Step
Bolt
Bolt
Shoulder
Stove
Door
Figure 14 - Catch Bolt and Door Claw Orientation
Adjusting
Nut
Bolt Stop
Catch
Bolt
Door
Claw
Door
INSTALLATION
Stove Cavity Assembly