![background image](http://html.mh-extra.com/html/desa/sgs3124n/sgs3124n_owners-operation-and-installation-manual_2485945016.webp)
www.desatech.com
107068-01K
16
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
Each log is marked with a number. These numbers
will help you identify the log when installing. It
is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate base
behind the burner (see Figure 18).
2. Locate the notches on the back of the front log
(#2). Slide these notches over the tabs of the
grate base (see Figure 19).
3. Locate the notches in the bottom of the
crossover log (#3). Place the crossover log on
top of the back log and front log. Make sure
the notches of the crossover log line up with
rectangular knobs on top of the back and front
logs (see Figure 20).
4. Add lava rock around base of heater if desired.
Do not place lava rock on logs or burner.
Figure 18 - Installing Back Log
Back Log (#1)
Peg
Peg
Hole
Figure 19 - Installing Front Log
Front Log
(#)
Notch
Tabs of
Grate Base
Figure 20 - Installing Crossover Log
Crossover
Log (#)
Notch
Rectangular
Knob
Notch
Rectangular
Knob