![background image](http://html1.mh-extra.com/html/desa/ec18nr/ec18nr_owners-manual_2485857022.webp)
www.desatech.com
122526-01B
22
Figure 38 - Correct VCC Log Placement
18" Models
24" Models
30" Models
INSTALLATION
Continued
WARNING: Use only one type
ember material. Do not mix.
Platinum Bright Ember placement.
Add
embers to front, flat burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
flat burner just behind horizontal ports as
shown in Figure 27, page 19.
Ceramat Ember placement.
Add embers
to front flat burner. Gently remove embers
from bag using gloves or tweezers.
(This
material is a skin irritant. Gloves or
tweezers are recommended to prevent
skin irritation).
Separate pieces of ember
material and place on surface of flat burner
as shown in Figure 28, page 19 overlap
-
ping ember pieces 1/4". Apply four pieces
to front ports and 2 pieces to back ports.
Additional glowing effect can be achieved
by fraying edges of ember material.
WARNING: Do not operate
unit without ember material cor-
rectly in place as shown in Fig-
ures 27 and 28, page 19. Do NOT
place ember material anywhere
else on the unit. Use only em-
ber material supplied with unit.
Excessive or incorrectly placed
ember material may produce
carbon monoxide or soot.
WARNING: Do not use any
other ember material not sup-
plied with this unit.
10. Place rock wool material on front flat
burner in areas away from ports as shown
in Figure 29, page 19.
11. Add lava rock and small decorative logs
around base of heater if desired.
DO NOT
place rock or additional logs on front
burner or on logs.
Placing any material
on unit other than ember material on front
burner may result in production of carbon
monoxide or soot. Use lava rock to hide
wires from switch/log to control valve.
Place switch/log so the switch is easy to
access.