Diamond Shield Crystal
Instruction Manual
Page 15
This program is executed by pressing the
START
button.
Beforehand the device checks the electrical contact (see "Contact
Control").
Contact Control
Before a sequence or a single program will be executed, the device
checks whether the required electrical contact exists.
If the contact is not good enough, the unit will beep every 3 seconds.
By pressing the "OK" button, the frequency program can be
executed. However, this is only useful for testing purposes.
If the required contact is made, the unit will display for a short time
the resistance in Kiloohm (kΩ) and then automatically start the
execution of the frequency program.
During the execution of frequencies
Display
In the headline the sequence name and the name of the
current single frequency program are shown in turns.
Below the remaining execution time is displayed (minutes:
seconds).
Below the intensity is displayed.
◦
For frequency programs with current control the actual
voltage is displayed on the left side. On the right side the
selected intensity is displayed in milliamps (1/1000
amps).
◦
For frequency programs without current control the
actual voltage in volts is displayed.
DS 11
00:07
0.6V 0.30mA
Diamond Shield
00:07
0.6V 0.30mA