Derbi ATV DXR 200, Workshop Manual

Page: 40 / 194

39
3-19. T
ON
-
IN
A
DJUSTMENT
(F
IG
. 3-32, 3-32/ 3-33/ 3-34/ 3-35)
01. place the ATV on a level place
02. check the Toe-in, if out of specification, be adjusted.
NOTE
1. MARK BOTH FRONT TIRE TREAD CENTRES.
2. RAISE THE FRONT END OF THE ATV
3. FIX HANDLEBAR STRAIGHT AHEAD
4. MEASURES THE WIDTH (A) BETWEEN THE MARKS
5. ROTATE THE FRONT TIRE 180 DEGREE THE MARKS
6. MEASURE THE WIDTH (B) BETWEEN THE MARKS “.
7. CALCULATE THE TOE-IN, “TOE IN = B-A”,
* TOE-IN: 0-10MM(0-0.39 IN)
NOTE
THE TOE-IN ADJUSTMENT STEPS:
1. PLACE THE CONFIRMATION MERCIES (1) ON THE BOTH TIE-RODS END-
2. LOOSEN THE ROD END LOCKOUTS (2) OF BOTH TIE-RODS.
3. THE SANE NUMBER OF TURNS SHOULD BE GIVEN TO BOTH TIE-RODS (3) L AND R UNTIL SPECIFIED
TOE-IN IS OBTAINED.
4. TIGHTEN THE ROD END LOCKOUTS (2) OF BOTH TIRE-RODS.
* TORQUE LOCKNUT: 3.0 KG-M
3-20. F
RONT SHOCK ABSORBER ADJUSTMENT
(F
IG
. 3-35)
01. adjust: the spring prelate by turning adjuster increase or decrease
02. the police softer (2) =
position (A)
standard = position (B)
stiffer (3) = position (C,D,E)
WARNING
ALWAYS ADJUST: BOTH FRONT SHOCK ABSORBER SPRING PROLATE TO THE SAME SETTING. UNEVEN
ADJUSTMENT CAN CAUSE POOR HANDLING AND LOSS OF STABILITY.
3-21. R
EAR SHOCK ABSORBER ADJUSTMENT
(F
IG
. 3-37, 3-38)
Check the rear shock absorbed (1) function for any damage -- replace
NOTE
LENGTH OF ABSORBER: FREE 380+/-3MM STROKE 70MM (A) FIG. 3-38
OPTION
Adjustable rear-absorber with spring prolate -- OPTION
01. looser, the locknut
02. adjust the spring prolate, the length of spring (install) changes 1.5mm (0.06 in) per turn of the adjuster.
03. turn adjuster clockwise increase the spring prolate turn adjuster counter-clockwise: decrease the spring
prolate
* Torque locknut:
5.5 kg-m