Dentsply Sirona
Operating Instructions Primescan Connect
6 Maintenance
6.1 Cleaning, disinfection, and sterilization
67 97 216 D3801
D3801.201.01.03.02 2022-09
63
6.1.4
Cleaning the inside of the sleeve window
NOTE! This process applies only to the window sleeve (standard
sleeve). If you notice during the scanning process that the inside of the
window sleeve (standard sleeve) is dirty, then follow the process
described below:
1.
Remove the sleeve from the scanner body (see "Removing the
sleeve [→ 52]").
2.
Place the white protective sleeve on the scanner head and place
the scanner body in the scanner holder.
3.
Gently tap the sleeve on a soft surface / on your hand.
4.
Blow out the sleeve with compressed air.
5.
NOTE! Do not moisten the inside of the sleeve window with liquid
(this can lead to marks). Clean the inside of the steel part with
ethanol or isopropanol.
Ensure that the removed impurities do not drop inside onto the
sleeve window.
Wipe the inside of the steel sleeve with a clean, dust-free and
grease-free cloth and ensure that no droplets remain.
6.
Remove the scanner body from the holder and remove the white
protective sleeve.
7.
Before placing the sleeve on it, clean the scanner head with a
clean, dust-free and grease-free cloth to remove any dirt/adhesions.
8.
Carefully re-attach the sleeve and lock it in place (see "Attaching
the sleeve [→ 52]"). To prevent the scanner from falling, hold it in
other places, not just on the sleeve.
Check whether the process has had the desired effect until now.
9.
NOTE! Do not allow any finger sweat or external pollutants to
access the sleeve. If contamination is still visible, then clean the
inside of the sleeve window with a cleaning swab that is suitable for
the cleanroom. This type of cleaning swab has been added to the
scope of delivery. If you have not received any cleaning swabs, you
can order them using REF 65 04 364. Ensure that finger sweat or
external pollutants are not able to access the sleeve.
10. Carefully re-attach the sleeve and lock it in place (see "Attaching
the sleeve [→ 52]"). To prevent the scanner from falling, hold it in
other places, not just on the sleeve.
