Dentsply Sirona
Operating Instructions Primescan Connect
4 Installation and commissioning
4.1 Transport and unpacking
67 97 216 D3801
D3801.201.01.03.02 2022-09
29
4
Installation and commissioning
4.1
Transport and unpacking
All products from Dentsply Sirona devices are carefully checked prior to
shipment. Please perform an incoming inspection immediately after
delivery.
1.
Check the delivery note to ensure that the consignment is complete.
2.
Check whether the product shows any visible signs of damage.
NOTE
Damage during transport
If the product was damaged during transport, please contact your
carrying agent.
NOTE
Damage due to extreme temperatures
After transporting or storing the system under extreme temperatures,
it is recommended to wait 12 hours before putting the system into
operation. To do this, the system must be removed from the storage
case.
NOTE
Observe operating conditions
The storage case included in the scope of delivery may only be used
for storing the product under the operating conditions specified in the
"Technical data [→ 20]" section.
CAUTION
Risk of cross-contamination
After storing and removing the system from the storage case, all
components must be reprocessed before use / deployment (see
section "Cleaning, disinfection, and sterilization [→ 47]").
If return shipment is required, please use the original packaging for
shipment.
4.2
Disposal of packaging materials
The packaging must be disposed of in compliance with the relevant
national regulations. Observe the regulations applicable in your country.
4.3
Scope of supply
The detailed scope of supply is specified in the document "Checklist".
4.4
Initial startup
You can commission the system yourself as the user.
