5 Maintenance
EN
9
M
IDWEST
®
A
UTOMATE
®
Automated Handpiece Maintenance System
5
Maintenance
Using Midwest
®
Plus Automate Spray Can
Insert Spray Can
Open side door.
Lift lever and hold.
Fully seat spray can in holder.
Release lever.
Close side door.
NOTE:
Use only original Midwest
®
Plus Automate Spray Cans.
Remove spray can
Open side door.
Lift lever and hold.
Tilt bottom of can outwards.
Pull can out.
Release lever.
Close side door.
Disposing empty spray cans
Follow local regulations for disposal.
Safety information
Check for any leaks every time a new bottle is installed!
Replace faulty or leaky spray cans immediately!
Protect the spray can from direct sunlight!
To change automate absorption pad and particulate filter
Open the front door.
Pull out and remove saturated absorption pad from the two holding brackets.
Hang new absorption pad on to the two holding brackets.
Close the front door.
NOTE:
Use only original Midwest
®
Absorption Pads and Particulate Filters
It is recommended to replace the absorption pad each time a new Midwest
®
Plus Automate Spray Can is used, or more
frequently as needed.
To change automate particulate filter
NOTE:
It is recommended to replace the particulate filter at every third time a new absorption pad is replaced or as necessary.
Open the front door.
Pull out and remove yellow particulate filter at the bottom of the unit behind the absorption pad.
Place a new particulate filter with the yellow side faced down.
Ensure absorption pad is positioned back in place.
Close the front door.
NOTE:
Use only original Midwest
®
Particulate Filters (included in the Midwest
®
Automate
®
Absorption Pad Kit).
Insert Spray Can
Remove Spray Can
