Dentsply Sirona inEos X5, Operating Instructions Manual

Page: 37 / 56

Dentsply Sirona
Operating Instructions inEos X5 9 Performing 3D acquisition
9.1 General
64 17 096 D3586
D3586.201.01.11.02 07.2018
37
3. Position the impression tray as per the illustrations in the software.
4.
Select the image catalog for the jaw section which is initially aligned
with the camera.
5.
Start the acquisition and follow the instructions and illustrations in
the software for changing the jaw.
NOTE! When performing double arch impression scanning, observe
the following points:
● Aligning the model:
– The buccal side of the impression must always point toward the
retaining screw.
– In the case of quadrant impressions, place the impression tray in
the central holder position in such a way that the last distally
cast tooth is centrally perpendicular to the rotary plate.
● Aligning the holder in the scanner:
– The holder used for scanning the double jaw impressions has a
groove. Position this in such a way that it is vertical above the
light barrier opening of the rotary plate.
9.1.4 Model options
For all image catalogs (with the exception of the buccal registration), it
is possible to specify for each new case whether the palate areas are
taken into account for calculating the model or automatically ignored.