Denso BHT-700QWB-CE, User Manual

Page: 57 / 182

39
2D Code Handy Terminal
3.4.1 Connector Communication
Depending on the computer interface to which the BHT is being connected, or the communcation unit
used, the user can choose between an RS-232C, USB or Ethernet connection.
Place the BHT on the communication unit (CU-733, CU-714) and transmit data.
Requests
Handling the CU-714
•
A Category 5 (Cat 5) LAN cable or higher is required when using the CU-714 in 100BASE-TX networks.
Successful communication may not be possible with other cables.
•
Do not forcibly insert the LAN connector or pull the cable strongly. Failure to observe this may result in
damage to the connector or cable.
•
The MAC address is written on the nameplate on the rear of the CU-714.
The BHT-700 RS-232C interface has no signal line for ActiveSync connection, and therefore ActiveSync
connection via RS-232C cannot be used.
CU-733: RS232C or USB
CU-714: Ethernet