Denso BHT-700QWB-CE, User Manual

Page: 50 / 182

32
BHT-700QWB-CE/700QWBG-CE
3.1 Scanning 2D Codes or Barcodes
Follow the procedure below to scan 2D codes or barcodes.
1.
Turn the BHT power ON.
2.
Bring the reading window to a target code to be
scanned, and press the trigger switch.
3.
The BHT turns the marker beam (laser) and
illumination LED on to indicate the scanning range
and scan the target code, respectively.
Codes can be read also by pressing the Scan key.
When the BHT has read the code successfully,
the indicator LED will illuminate in blue.
−
Point
−
The code scanning method may differ
depending on the application. Perform
scanning in accordance with the
instructions provided in the application
User’s Manual.
−
Note
−
If required, clean dirty labels before scanning.
It may not be possible to perform scanning in direct sunlight.
If the code is on a curved surface, perform scanning in the center of the laser light emission
range.
If the code reading window is pulled away from the code, the scannable code range will become
narrower than that of the laser light emission.
Do not use the BHT in the vicinity of radio equipment. This may cause the BHT to malfunction.
Blue LED ON
Power key