Denso BHT-700QWB-CE, User Manual

Page: 43 / 182

25
2D Code Handy Terminal
2.4 Initial Setup
It is necessary to perform touch screen calibration and set the date and time when turning ON the BHT power for the
first time. Press the
power key to turn ON the BHT power. The calibration screen should then display. If the calibration
screen does not display, first perform a “full reset”. Refer to “2.6 Resetting and Full Resetting” for details of the full
reset method.
1.
Press the power key to turn ON the BHT power.
2.
The screen on the right displays.
Tap the center of the “+” with the stylus for approximately 1 second.
Tap the center of the “+” each time it moves.
(The “+” mark moves from the center of the screen to the upper left, lower
left, lower right and upper right, making a total of 5 positions.)
3.
Press the ENT key.
Press the ENT key or tap the screen to complete touch screen calibration
and display the data and time setting screen.
4.
Set the date, time and time zone and then tap the OK button.
Power key