199
Barcode Handy Terminal
4.5.18 Downloading/Uploading the System Message File
(SYSTEM MESSAGE Menu)
The system message file is a file (file name: “_B80MSG.FN3”) used by the system to display messages
such as “Shutdown in progress. Do not remove the battery.” or “Charge the battery!”.
Downloading/Uploading the System Message File
(1) Upload the system message file to the host computer and so on.
(2) Download the uploaded system message file at another BHT.
Uploading the System Message File
Create a system message file based on the current system message settings and upload it to the host
computer and so on. After uploading, delete the created system message file.
Downloading the system message file
Receive the system message file from the host computer and so on to which it was backed up, and after
setting the stored system messages, delete the received system message file.
The communication parameters, communication protocol, and interface set at “[5] Setting the
communication environment” in Chapter 4.5.6 [5] “System Environment Settings” are used when
uploading and downloading.
- Point -
System messages are normally set when the BHT is shipped from the factory,
and therefore operation at this menu is unnecessary.
Use the following procedure to download and upload the system message file.
5.
Press the
6
key while holding down the
SF
key at the SYSTEM
MENU.
The SYSTEM MESSAGE menu is displayed as shown on the right.
[1: DOWNLOAD]:
Downloads the system message file.
[2: UPLOAD]:
Uploads the system message file.
Refer to the following section for details of the above items.
Press and hold the
BS/C
key to return to the SYSTEM MENU.
Summary of Contents for BHT-1306B
