Denon SC6000 PRIME, User Manual, Page: 13 / 88

13
Playback & Cueing
To play or pause a track
, press Play / Pause (

/

).
To scratch a track , press Vinyl so it is lit brightly and then move the platter .
To set the initial cue point , press Shift + Cue at the desired location during playback.
To return to the initial cue point and stop , press Cue . The button will flash while the unit is paused at the cue point.
To return to the initial cue point and keep playing , press Shift + Play / Pause (

/

).
To reverse playback , press Shift + Censor / Reverse . The button will flash while playback is reversed.
To return to normal playback , press Censor / Reverse .
To censor playback , press and hold Censor .
To return to normal playback , release Censor . Normal playback will resume from where it would have been if
you had never engaged the Censor feature (i.e., as if the track had been playing forward the whole time).
To skip to the previous or next track , press one of the Track Skip

/

buttons.
To return to the beginning of a track , press Track Skip

in the middle of a paused track.
To scan quickly through the track , press and hold Shift and then press one of the Beat Jump buttons.
To enable or disable Slip Mode , press Slip . In Slip Mode, you can jump to cue points, use the platters, or pause the
track while the track’s timeline continues (the lower half of the waveform in the touchscreen will continue moving
forward). When you stop whatever action you are performing, the track will resume normal playback from where it
would have been if you had never done anything (i.e., as if the track had been playing forward the whole time).
To jump to a specific location in the track :
•
If Needle Lock is disabled : tap the desired location in the track overview.
•
If Needle Lock is enabled : pause playback and then tap the desired location in the track overview. Alternatively,
make sure the platter is in Vinyl Mode (press Vinyl so it is lit), touch the top of the platter , and tap the desired
location in the track overview.
See Configuration > Preferences to learn about Needle Lock.
To zoom in and out of the waveform , place two fingers on the display and spread them apart or pinch them together.
Alternatively, turn the Select/Zoom knob.
Looping & Beat-Jumping
To create and activate an auto loop , press the Auto Loop knob.
To set the auto loop length , turn the Auto Loop knob to select the number of beats: 1 / 32 , 1 / 16 , 1 / 8 , 1 / 4 , 1 / 2 , 1 ,
2 , 4 , 8 , 16 , 32 , or 64 .
To create and activate a manual loop , press Loop In to set the start point, and then press Loop Out to set the
end point. The loop will be activated immediately, and the loop will be indicated as a shaded area in the
waveform and track overview.
To deactivate a loop , press the Auto Loop knob.
To move the loop , press and hold Shift and turn the Auto Loop knob while the loop is activated.
To double or halve the length of a loop , turn the Auto Loop knob while the loop is activated.
To manually edit the beginning or end of a loop, press Loop In or Loop Out respectively, then move the platter
left or right to shorten or extend the loop region. Commit the edit by pressing Loop In or Loop Out again.
To beat-jump through a track , press one of the Beat Jump buttons. Each press will skip through the track by the
length of an auto loop, which you can set by turning the Auto Loop knob.