12
Performance Controls
24.
Shift
: Press and hold this button to access secondary functions of other controls.
25.
Slip
: Press this button to enable or disable Slip Mode. In Slip Mode, you can jump to cue points, use the
platters, or pause the track while the track’s timeline continues (the lower half of the waveform in the
display will continue moving forward). In other words, when you stop whatever action you are
performing, the track will resume normal playback from where it would have been if you had never done
anything (i.e., as if the track had been playing forward the whole time).
26.
Censor
/
Reverse
: Press this button to activate or deactivate the Censor feature: the playback of the
track will be reversed, but when you release the button, normal playback will resume from where it would
have been if you had never engaged the Censor feature (i.e., as if the track had been playing forward the
whole time).
Press and hold
Shift
and then press this button to reverse the playback of the track normally. Press this
button again to return playback to the normal forward direction.
27.
Performance Pads
: These pads have different functions on each deck depending on the current pad
mode. See
for more information.
28.
Hot Cue
: Press this button to enter Hot Cue Mode.
29.
Loop
: Press this button once to enter Manual Loop Mode. Press it once more to enter Auto Loop Mode.
30.
Roll
: Press this button to enter Roll Mode.
31.
Slicer
: Press this button to enter Slicer Mode and press it again to enter Slicer Loop Mode.
32.
Parameter
/
: Use these buttons for various functions in each Pad Mode.
33.
Loop In
/
Loop Out
: Press either of these buttons to create a Loop In or Loop Out point at the current
location. Their placement will be affected by the
Quantize
and
Smart Loops
settings. See
for more information.
34.
Auto Loop
/
Loop Move
: Turn this knob to set the size of an automatic loop. The value will be shown in
the touchscreen and platter display. Press this knob to activate or deactivate an automatic loop at the
current location of the track.
Tip
: You can assign auto loops to pads in Manual Loop Mode. See
for more information.
Press and hold
Shift
and turn this knob to shift the active loop to the left or right.
35.
Beat Jump
: Press either of these buttons to skip backward or forward through the track.
Press and hold
Shift
and then press one of these buttons to increase or decrease the beat jump size.
Front Panel
1.
Front USB Port
: Connect a standard USB drive to
this USB port. When you select that USB drive as a
source (press the
Source
button), you can use the
display to select and load tracks on your USB drive.
There are also two similar USB ports on the rear
panel. You can use the included USB extension cable
to accommodate larger or smaller USB thumb drives.
2.
SD Card Slot
: Insert a standard SD or SDHC card to
this slot. When you select that SD card as a source
(press the
Source
button), you can use the display to
select and load tracks on your SD card.
1
2