SPECIAL MODE
Special mode setting button
No.1 - 3 :When the power is in standby mode, hold down buttons A and B and press the power button to turn on the power.
No.4 : Hold down button A and connect the power cord to an outlet.
No.5 : When the power is in standby mode, hold down button A and connect the power cord to an outlet.
No.
Mode
Button A
Button B
Contents
1 Version Check
Source
Bluetooth Displya the version.
System u-com, FPGA, USB, BT and Bluetooth
address.
2 Display / LED check
Source
Bluetooth Test of display.
3 Protection History
Source
Bluetooth Displaying and clearing the protection history.
4 Initialization for the
factory
Power
-
Initialize factory setting.
5
Owner’s Manual
described
initialization
Source
-
This operation is described Owner's Manual.
This initialization, except for the following two points are the same as
the factory initialization.
It is not clear the protection of history.
Mode No.1-3 changes each time the button "Source" is pressed.
To exit the special mode disconnect the adapter plug.
Power operation button (
X
)
Bluetooth button
Input source select button
Protection circuit indicator
20
Summary of Contents for PMA-50
