Denon PMA-150H, Owner'S Manual

Page: 74 / 145

0
Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0
When this unit is functioning as a D/A converter, sound is not output from the
computer’s speakers.
0
If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0
When an error occurs on the computer, disconnect the USB cable and restart the
computer.
0
The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0
Use a cable that is 3 m or less to connect to the computer.
Connect and playback from a digital
device (Coaxial/Optical 1/Optical 2)
1
Prepare for playback.
Check the connection, then turn on this units. (“Connecting a digital
device” (
v
p. 24))
2
Press COAXIAL or OPTICAL to switch the input source
to “Coaxial”, “Optical 1” or “Optical 2”.
3
Play the component connected to this unit.
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
0
When “TV Input” is set in the menu, this unit automatically turns on when the TV
connected to the unit is turned on, and the input source switches to “Optical 1”,
“Optical 2” or “Coaxial”. (
v
p. 94)
Contents Connections Playback Settings Tips Appendix
74
Front panel Rear panel
Remote control
unit
Index