Denon HEOS, Owner'S Manual

Page: 27 / 67

Connecting to a WPS network
Solution Refer to Page
0
If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS wireless device can optionally connect to your
network using the “Push Button” method by following these steps:
Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the Connect button on the rear panel of the HEOS device for 3 seconds.
3. The LED on the front of the device will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the device will turn solid blue.
5
Resetting your HEOS device
Solution Refer to Page
0
Resetting your HEOS device will clear out the wireless network info, EQ, and name but retain it’s current software. You will have
to use Settings - Add Device to reconnect the HEOS device to your home network before it can be used.
To reset your HEOS device, press and hold the RESET buttons located on the back of the HEOS device for 5 seconds until the
front LED begins to flash amber.
–
Contents Setup Use Troubleshooting Status LED Appendix
27