Settings
AUDIO OUT connectors
Height
Sp
Dolby Sp
NOTE
Front Layout
Middle
Layout
Rear Layout
HEIGHT 1
HEIGHT 2
HEIGHT 3
HEIGHT 4/
FRONT WIDE
8ch
None
z
3
z
6 Front Height &
Center Height
Top Middle &
Top Surround
Rear Height
Front Height
Rear Height
Top Middle
L: Top
Surround
R: Center
Height
6ch
2ch
z
3
z
6 Front Height &
Center Height
Surr. Dolby &
Top Surround
Rear Height
Front Height
Rear Height
Surround
Dolby
L: Top
Surround
R: Center
Height
z
1 This can be selected when using Surround Back speakers.
z
2 For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup
in place of Surround Height speakers.
z
3 This can be set when “Assign Mode” in the menu is set to “13.1ch” or “11.1ch”. (
z
4 Use 2 sets of Height speakers in the appropriate sound modes for Dolby Atmos, DTS:X or Auro-3D playback.
Use the Front Height and Rear Height speakers for Dolby Atmos or DTS:X playback.
Use the Front Height and Surround Height speakers for Auro-3D playback.
z
5 This can be set when “Assign Mode” in the menu is set to “13.1ch” or “11.1ch”, and “Floor” - “Layout” is set to “5ch” or “5ch & SB”. (
z
6 This combination cannot be selected when Front Wide speakers are being used.
n
Settings
Select the signal to be output from the selected speaker terminal.
0
Only “Center” and “None” can be set for the CENTER speaker
terminal.
0
The HEIGHT4/FRONT WIDE speaker terminal is not used.
o
View Terminal Config.
This shows how to connect the speaker terminals and PRE OUT
connectors for your “Amp Assign” setting on the menu screen.
233
